CNC Stubbing Wheel

1.CNC stubbling wheel is designed to calibrate the thickness of the countertop where it overhangs the cabinets.

This is important because not all slabs are equal thickness which can throw off your seams at install.

2.This cnc stubbing wheel also allows you to create a smooth to the touch finish on the underside of tops,because one way to tell if the countertop installation is done by a professional installer is to check the underside of the overhanging countertop, like a bar top.

If done professionally, one can tell that the underside has been smoothed out and all of the rough surface is gone, leaving a nice smooth surface. The ladies will also appreciate this kind of an installation, as it will not snag their pantyhose or scrape their knees under the bar countertop.

CNC stubbling wheel Advantages

Calibrates about 2 inches in width of the underside of countertop's edge

• Grinds down the rough surfaces and leaves them smooth to the touch
• One of the determining factors of a professional countertop installation
• Feed Rate: 500-1200mm/min
• RPM: 5000-5500

Other specifications are available upon request